Jumper settings, Jumper – ProSoft Technology MVI69L-MBS User Manual
Page 12
Advertising
![background image](/files/866077/content/doc012.png)
Start Here
MVI69L-MBS ♦ CompactLogix Platform
User Manual
Communication Module
Page 12 of 154
ProSoft Technology, Inc.
January 6, 2014
1.4
Jumper Settings
When the module is manufactured, the port selection jumper is set to RS-232. To
use RS-422 or RS-485, you must set the jumper to the correct position. The
following diagram describes the jumper settings.
Note: Jumper pin placement on the circuit board may vary.
Advertising