ProSoft Technology MVI69E-MBS - Manual (Page 13)

MVI69E-MBS ♦ CompactLogix Platform Start Here
Communication Module User Manual
ProSoft Technology, Inc. Page 13 of 162
January 6, 2014
The following illustration shows the MVI69E-MBS jumper configuration, with the
Setup Jumper OFF.
1.5 Installing the Module in the Rack
Make sure the processor and power supply are installed and configured before
installing the MVI69E-MBS module. Refer to the Rockwell Automation product
documentation for installation instructions.
Warning: Please follow all safety instructions when installing this or any other electronic devices.
Failure to follow safety procedures could result in damage to hardware or data, or even serious
injury or death to personnel. Refer to the documentation for each device to be connected to verify
that suitable safety procedures are in place before installing or servicing the device.
After you verify the jumper placements, insert the MVI69E-MBS into the rack.
Use the same technique recommended by Rockwell Automation to remove and
install CompactLogix modules.
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.