ProSoft Technology MVI69-DNPSNET - Manual (Page 26)

MVI69-DNPSNET ♦ CompactLogix or MicroLogix Platform Configuring the MVI69-DNPSNET Module
Distributed Network Protocol Interface Module
Page 26 of 119 ProSoft Technology, Inc.
November 3, 2008
2.2 [Backplane Configuration]
This section of the file describes the database setup and module level
parameters.
2.2.1 Module Name
0 to 80 characters
This parameter assigns a name to the module that can be viewed using the
configuration/debug port. Use this parameter to identify the module and the
configuration file.
2.2.2 Read Register Start
0 to 8899
This parameter specifies the starting register in the module where data will be
transferred from the module to the processor. Valid range for this parameter is 0
to 8899.
2.2.3 Read Register Count
0 to 8900
This parameter specifies the number of registers to be transferred from the
module to the processor. Valid entry for this parameter is 0 to 8900.
2.2.4 Write Register Start
0 to 8899
This parameter specifies the starting register in the module where the data will be
transferred from the processor to the module. Valid range for this parameter is 0
to 8899.
2.2.5 Write Register Count
0 to 8900
This parameter specifies the number of registers to transfer from the processor to
the module. Valid entry for this parameter is 0 to 8900.
2.2.6 Block Transfer Size
60, 120 or 240
This read-only parameter specifies the number of words in each block transferred
between the module and processor. Valid values for this parameter are 60, 120
and 240.