ProSoft Technology MVI69-DNPSNET - Manual (Page 29)

Configuring the MVI69-DNPSNET Module MVI69-DNPSNET ♦ CompactLogix or MicroLogix Platform
Distributed Network Protocol Interface Module
ProSoft Technology, Inc. Page 29 of 119
November 3, 2008
2.3.10 BI Class
0=disable, else 1 to 3
This parameter specifies the default class to be utilized for all the binary input
points in the DNP database that are not defined in the override list section.
2.3.11 AI Class
0=disable, else 1 to 3
This parameter specifies the default class to be utilized for all the analog input
points in the DNP database that are not defined in the override list section.
2.3.12 Float Class
0=disable, else 1 to 3
This parameter specifies the default class to be utilized for all the floating-point
input points in the DNP database that are not defined in the override list section.
2.3.13 AI Deadband
0 to 32767 data units
This value sets the global deadband for all analog input points. When the current
value for an analog input point is not within the deadband limit set based on the
last event for the point, an event will be generated.
2.3.14 Float Deadband
0 to 32767 data units
This parameter specifies the default deadband value assigned to all points not
defined in the override list for the floating-point input point type in the DNP
database.
2.3.15 Select/Operate Arm Time
1 to 65535 milliseconds
This parameter sets the time period after select command received in which
operate command will be performed. After the select command is received, the
operate command will only be honored if it arrives within this period of time. Valid
arm timeout values are 1 to 65535 milliseconds. This example shows the value
set to 2000 milliseconds.
2.3.16 Write Time Interval
0 to 1440 minutes
This parameter sets the time interval to set the need time IIN bit (0=never), which
will cause the master to write the time. Stored in milliseconds in the module
memory.