Epson EpiqVision Mini EF11 1000-Lumen Full HD Laser 3LCD Projector - Manual (Page 102)

102
Solutions When "No Signal" Message Appears
Solutions When the Image is Not Rectangular
Solutions When Only a Partial Image Appears
Solutions When the Image Contains Noise or Static
Solutions When the Image is Fuzzy or Blurry
Solutions When the Image Brightness or Colors are Incorrect
Solutions to Sound Problems
Parent topic: Solving Problems
Solutions When No Image Appears
If no image appears, try the following solutions:
• Press the A/V mute button on the projector remote control to see if the image was temporarily
turned off.
• Check the status light to confirm the projector is operating normally.
• Make sure all necessary cables are securely connected and the power is on for the projector and
connected video sources.
• Try using a shorter HDMI cable.
• Try connecting the video source directly to the projector.
• Press the projector's power button to wake it from standby or sleep mode. Also see if your connected
computer is in sleep mode or displaying a blank screen saver.
• Make sure the connected device meets the HDMI CEC standard. See the documentation supplied
with the device for more information. If necessary, set the CEC function for the connected device
again and restart the device. Turn off the projector and the connected streaming device or video
source, and then turn them back on.
• Make sure the connected device does not require MHL; the projector's HDMI port does not support
MHL.
• If you are projecting from a laptop computer, make sure it is set up to display on an external monitor.
• If you are projecting from a computer using an HDMI cable, turn off the computer and the projector.
Make sure the HDMI cable is securely connected, turn the projector on, then turn the computer on.
• Make sure the computer's display resolution does not exceed the projector's resolution and frequency
limits. If necessary, select a different display resolution for your computer. (See your computer manual
for details.)