Denon DNP-2000NE High-Resolution DAC Audio Streamer with HEOS (Silver) - Manual (Page 100)

Switching the function of the volume buttons on the remote control
1
2
ENTER
MUTE
VOLUME df
If connecting a power amplifier to the analog audio output terminals
(VARIABLE) of this unit, you can change the operation mode of the
included remote control so that the volume of the power amplifier can be
adjusted from this unit. There are two remote control operation modes:
amplifier operation mode and network audio player operation mode.
Amplifier operation mode adjusts the volume of a Denon amplifier and
network audio player operation mode adjusts the volume of the audio
signal output from the analog audio output terminals (VARIABLE) of this
unit. The factory default setting for the remote control operation mode is
the amplifier operation mode.
0
Be sure to check the operation of each unit after setting the remote control
operation modes.
0
Switch between the remote control operation mode settings by pressing the
VOLUME df and MUTE : buttons.
0
The remote control operation modes returns to the default settings when the
batteries are removed. Set the remote control operation modes again after
replacing the batteries.
Contents Connections Playback Settings Tips Appendix
100
Front panel Rear panel
Remote control
unit
Index