Factory restore – Denon DNP-2000NE High-Resolution DAC Audio Streamer with HEOS (Silver) User Manual
Page 122
Factory Restore
When the unit or the network functions do not work properly, operation may be improved by performing the Factory Restore.
Perform this operation if it does not work after attempting “General” - “Reset” of the settings menu. (
After performing the Factory Restore, various settings are reset to the default settings. Configure the network settings and update the firmware again.
SOURCE
BACK
WARNING
By initiating Factory Restore mode, you will be installing limited
recovery firmware on this unit. Functionality will remain limited
until a firmware update is performed over the Internet. Do not
perform a Factory Restore if you do not have this unit connected
to your home network.
1
Unplug the power cord from the power outlet.
2
Plug in the power cord while holding down BACK and
SOURCE.
3
When “Factory Restore” appears on the display,
release the buttons.
When the Factory Restore is complete, “Factory Restore
Completed” appears on the display for about 5 seconds, and the unit
automatically restarts.
0
This operation takes time because it requires reconnecting to the network,
restoring and updating the firmware.
0
If this operation does not improve the problem, contact our customer service
center.
NOTE
0
Do not turn off the power until the Factory Restore is complete.
122