Denon DNP-2000NE High-Resolution DAC Audio Streamer with HEOS (Silver) - Manual (Page 84)

TV
TV Input
Set this when playing audio from a TV on this unit. When the TV is turned
on, this unit turns on and the input source is automatically switched to
“HDMI ARC”, “Optical 1”, “Optical 2” or “Coaxial” so that the audio from the
TV can be played through this unit.
o Default Input
Set the input source to be used when playing audio from the TV
through this unit. Set this according to the jack on this unit being used
to connect to the TV (HDMI ARC, OPTICAL 1, OPTICAL 2 or
COAXIAL).
None / HDMI Out (ARC) / Optical In 1 / Optical In 2 / Coaxial In
(Default: HDMI Out (ARC))
o Auto-Play
When a TV audio source is input to this unit, the unit automatically
switches to the input source set in “Default Input” and the Auto-Play
function for playing TV audio on this unit is set.
On
(Default):
Enables the Auto-Play function.
Off: Disables the Auto-Play function.
0 The Auto-Play function does not work when “Default Input” is set to “None”.
Set “Default Input” in advance.
0
The Auto-Play function will not work if the sampling frequency of the audio
signal input from this unit’s OPTICAL 1 and 2 input terminals and COAXIAL
input terminal is 88.2 kHz or more. TVs normally output 48 kHz audio signals
and the Auto-Play function will work, but if you connect a device that outputs
an audio signal of 88.2 kHz or more and try to use it, the Auto-Play function
may not work.
Contents Connections Playback Settings Tips Appendix
84
Front panel Rear panel
Remote control
unit
Index