HP Color LaserJet Pro M454dw - Manual (Page 88)

4. Use the arrow buttons to enter the Subnet Mask and then press OK .
5. Use the arrow buttons to enter the Gateway and then press OK .
Link speed and duplex settings
The link speed and communication mode of the print server must match the network hub. For most situations,
leave the printer in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the
printer from communicating with other network devices. If you need to make changes, use the printer control
panel.
NOTE: This information applies only to Ethernet (wired) networks. It does not apply to wireless networks.
NOTE: The printer setting must match the setting for the network device (a network hub, switch, gateway,
router, or computer).
NOTE: Making changes to these settings causes the printer to turn off and then on. Make changes only when
the printer is idle.
1. Navigate to the Setup menu:
● Touchscreen control panel: From the Home screen on the printer control panel, swipe the tab at the
top of the screen downward to open the Dashboard, and then touch the Setup icon .
● 2-line LCD control panel: Press the OK button to display the Home screen. Use the arrow buttons to
navigate to Setup , and then press the OK button again.
2. From the Setup menu, touch or use the arrow buttons and the OK button to open the following menus:
1. Network Setup
2. Ethernet Settings
3. Link Speed
3. On the Link Speed menu, navigate to and select one of the following options:
Setting Description
Automatic The print server automatically configures itself for
the highest link speed and communication mode
allowed on the network.
10T Full 10 Mbps, full-duplex operation
10T Half 10 Mbps, half-duplex operation
100TX Full 100 Mbps, full-duplex operation
100TX Half 100 Mbps, half-duplex operation
1000T Full 1000 Mbps, full-duplex operation
4. Select OK to save the setting. The printer turns off and then on.
78 Chapter 5 Manage the printer ENWW