Heat & Glo Fireplace HEAT & GLOW XLR-N-AU - Manual (Page 45)

45 Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. o • 1/13
E. Junction Cord Information
The junction cord is installed at the factory. refer to figure
12.2. for more information.
D. Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105 °C rated wire. Wire must have high temperature
insulation.
Note: There is an alternative access to the junction cord.
This can be accessed by removing the valve assembly. See
Figures 11.1 and 11.2.
Figure 12.2. Junction Cord Information