Heat & Glo Fireplace HEAT & GLO SLR-B (COSMO) - Manual (Page 17)

Heat & Glo • SLR-B • 2195-900 Rev. P • 12/11 17
5
Framing and Clearances
A. Selecting Appliance Location
When selecting a location for the appliance it is important to
consider the required clearances to walls (see Figure 5.1).
WARNING! Risk of Fire or Burns! Provide adequate
clearance around air openings and for service access.
Due to high temperatures, the appliance should be locat-
ed out of traffi c and away from furniture and draperies.
NOTICE: Illustrations refl ect typical installations and are
FOR DESIGN PURPOSES ONLY. Illustrations/diagrams
are not drawn to scale. Actual installation may vary due to
individual design preference.
1 IN.
A
E
A
B
C
TOP VENT
ONE 90 0 ELBOW
ALCOVE
INSTALLATION
D*
TOP VENT
ONE 90° ELBOW
B
F
Figure 5.1 Appliance Locations
A B C D E F
Inches 53-1/32 48 75
See Section D.
Figure 5.5 & 5.6
19-9/32 17-3/4
Millimeters 1347 1218 1905 490 451
Unlike many traditional, single sided Heat & Glo fi replaces,
the SLR-B is recessed into surrounding framing. The left and
right nailing tabs were designed to ensure the fi replace is
recessed to the correct location within the framing materials.
Refer to Section 13 for detailed instructions on fi nishing.
It is important to follow the framing and fi nishing instruc-
tions step by step to ensure proper placement of fi replace
in the surrounding framing/fi nishing materials.