Henny Penny CW-114 - Manual (Page 15)

Model CW-216/CW-114
2-9. LIGHT SWITCH 1. Remove electrical power supplied to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove control side and panel.
3. Remove the wires from the switch. With test instrument check
across the terminals of the switch with the switch in the ON
position, then in the OFF position. With the switch in the ON
position the circuit should be closed. With the switch in the
OFF position the circuit should be open. If the switch checks
Step 3 defective replace by continuing with this procedure.
4. Remove the nut from control panel side and remove switch.
5. Install a new switch in reverse order.
6. Replace the end panel.
7. Turn on the power supply at the breaker box.
2-10. POWER SWITCH 1. Remove electrical power supplied to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the control side end panel.
3. Remove the electrical wires from the switch. With test
instrument check across the terminals of the switch with
the switch in the ON position, then in the OFF position. With
the switch in the ON position, the circuit should be closed.
Step 3 With the switch in the OFF position, the circuit should be open.
If the switch checks defective, replace by continuing with
this procedure.
103 2-7