Henny Penny CW-114 - Manual (Page 22)

Model CW-216/CW-114
2-19. RADIANT HEATER 3. Remove the electrical wires from the heater. Check with an
(Continued) ohmmeter across end terminals. The ohm reading should
be as follows:
CW-114 (208 volts) ................................ 43 ohms
CW-114 (230 volts) ................................ 53 ohms
CW-216 lower (208 volts) ...................... 43 ohms
CW-216 lower (230 volts) ...................... 53 ohms
CW-216 upper (208 volts) ...................... 108 ohms
CW-216 upper (230 volts) ...................... 132 ohms
If a heater checks defective, replace it by continuing with
this procedure.
Step 3 4. Slide the brackets off the defective heater and install brackets
on new heater.
5. Install the new heater in reverse order.
6. Turn on the power at the breaker box.
2-20. LIGHT SOCKET 1. Remove electrical power supplied to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the glass panel and the light bulb.
Light bulbs and glass may be hot. Severe burns could
result.
Step 3 3. Remove the four screws located at the bottom of the light box.
4. The light box can be pulled down by slightly spreading the
ceiling panel sides.
5. Remove the electrical wires from the socket.
6. Remove the two screws holding the socket to the light box.
7. Install a new light socket in reverse order.
8. Turn on the power at the breaker box.
2-14 103