Henny Penny CW-114 User Manual
Page 18
Model CW-216/CW-114
2-13. THERMOSTAT
4. Remove the thermostat knob by loosening the set screw
(Continued)
and pulling it off.
5. Remove the sensor bulb by pulling on the capillary tube.
6. Remove the two mounting screws from the thermostat.
7. Install a new thermostat in reverse order.
8. Replace the end panel.
9. Turn on the power supply at the breaker box.
Step 5
Step 6
2-14. INDICATING LIGHT
1. Remove electrical power supplied to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the control side end panel.
3. Cut the light wires just behind the light housing.
Step 3
4. Squeeze the plastic retainers on the light body and push the
light through the control panel.
2-10
103