Hitachi SJ2-CO - Manual (Page 8)

CHAPTER 2 MOUNTING METHOD OF OPTION
4
Figure 2-1 Installation of SJ2-CO (SJ200-2 + SJ2-CO)
Note: Optional operator
(SRW-0J/0EX) cannot be used via SJ2-CO .
Note : Please move the OPE/485 dip switch
bottom position labeled “OPE”.
2.1 Mounting method of option
Please connect the following cables first, and then attach the SJ2-CO to the front cover of SJ/L200-2.
[Installation step]
(1) mounting location
(2) Change the dipswitch position to lower ( OPE )
(3) Connecting the cables
The cables are shown as bellow:
Power input cable, Motor output cable, Input terminal cable, Output terminal cable, Analog input cable,
Analog output cable etc
Because the following cables cannot be connected, after the instllation of SJ2-CO.
Figure 2-1 describes how to mount the SJ2-CO to the SJ200-2.
Figure 2-2 describes how to mount the SJ2-CO to the L200-2.
Figure 2-3 describes how to remove the SJ2-CO to the SJ200-2.
Figure 2-4 describes how to mount the SJ2-CO and operator(OPE-SRmini) to the SJ200-2
Please mount the
SJ2-CO tightly to
the main body of
the inverter.
Then lift down the
plastic lever.
If the lever is not dropped down,
please lift up the lever, and remount
the unit again.