Heat & Glo Fireplace XLR-N-CE - Manual (Page 43)

43 Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. L • 3/13
D. Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
E. Junction Cord Information
The junction cord is installed at the factory. Refer to Figure
12.2 and 12.3. for more information.
Note: There is an alternative access to the junction cord.
This can be accessed by removing the valve assembly. See
Figures 11.1 and 11.2.
Figure 12.2. Junction Cord Information
BLUE
BROWN
GREEN/
YELLOW
Figure 12.3 Blower Circuit
240V BLOWER
JUNCTION CORD
AUX 300 CE
GROUND TERMINAL TO
FIREPLACE CHASSIS
COUNTRY OF
DESTINATION PLUG
OPTIONAL
F. Blower
An optional fan and auxilliary box are available for this
appliance. Refer to instructions provided with GFK-240V
fan kit.
Use of the fan requires that the Junction cord (factory in-
stalled) be connected to 220/240 VAC service before per-
manently enclosing the heater. The service cord is found
on the right exterior side of the unit. See Figure 12.3 for
wire connection detail.
TO
MODULE