Testing output or input cards, Testing controller cards, Led indicators – HP sv6 User Manual

Page 106: Table

Advertising
background image

hp scalable visualization digital compositor

compositor self-test sequence

Appendix A

106

the values should match. If the value does not match, two failing cards
are identified, the one driving the test value and the one receiving the
test value, as it is impossible to determine which of the two cards has the
failing bus connection.

testing output or input cards

The test can have two results. One is success. The other is failure, along
with a list of one or more cards that failed. This result is accessible to the
host through the compositor protocol. The result is also available without
the host. A successful test puts the cards into normal operation. If the
test fails, the speaker on the compositor sounds a long, low-pitch, failure
beep. If the controller has the ability to talk to the failing card or cards, it
will set the LEDs to red. This way the operator will be able to visually
identify failing cards.

testing controller cards

This procedure does not do any specific test of the controller card
backplane connections. Being a single connector, and having a position
that is the same for all configurations, it is believed that failure of the
card upon installation is unlikely. In the event there is a bent pin or a
poorly seated controller card, it is likely that the controller card will not
function at all, since it controls the power switch and the processor that
can test the other cards. Although very unlikely, it is possible that an
input or output card that fails the test may actually be a failure of one of
the pins on the controller card.

The test procedure depends of a few of the bus connections in order to
detect that a card is present in a slot. If one of these critical signals is
shorted or open, the test may miss a failure by not knowing that a card is
even in the slot, or the test may misidentify a card.

LED indicators

LED1

Card LEDs

ON=Compositor ready

Green = Working and connected

OFF= Compositor not ready

Yellow = Cable not connected, no signal

Red = Unintialized or ERROR

Advertising