HP sv6 - Manual (Page 36)

installation and user information
installation process
Chapter 2 36
installation process
NOTE Before attempting to install your hp visualization center sv6 system,
please read the Safety Information in Chapter 1 of this document.
This installation process assumes the following steps:
assessment
The assessment phase ensures that your computing needs are
appropriately addressed. Options or future opportunities are considered
at this stage so that system upgrade requirements are anticipated.
1. Review the hp visualization center sv6 Site Prep Guide to ensure that
all space, power, cooling equipment handling requirements, etc. are
understood. Take any future upgrades into consideration. For
Table 2-5
Assessment Thoroughly review the hp visualization center sv6 Site Prep
Guide.
Register an IP address and hostname for each workstation
and Digi switch in the system.
Take future upgrades into consideration.
Confirm all system and display requirements with the vendor
of your display(s)
Preparation for
Wide Field
Displays Order appropriate equipment and services
Prepare site as recommended in the hp visualization center
sv6 Site Prep Guide
Workstation
Installation Locate and setup:
• rack(s) of workstations
• console monitors, keyboard, peripherals
• cabling including power, network, etc.
Configuration Configure workstations including passwords, networking, etc.
Configure and calibrate any display options
Verification Locate and run verification test and demos