HP sv6 - Manual (Page 62)

installation and user information
usage
Chapter 2 62
usage
This section covers some general tasks the hp visualization center sv6
user may do. If you are looking for descriptions of hp visualization center
sv6 tools, skip to the How To Use hp visualization center sv6 Tools
section.
• X Server
To start the X server on the master system, run X:0 or go to init 3
to start up the X server and CDE. The master’s X server will
automatically start and control all slave X servers on the other
systems.
To kill the X server, press <Ctrl>+<Shift>+<Break> , then wait for
the X servers to stop.
Press <Ctrl>+<Shift>+<Break> again.
Press enter a couple of times to get the prompt back.
• X0screens Description
The /etc/X11/X0screens file details the X server configuration
information for the HP X server. The X0screens file is used to
configure many aspects of hp visualization center sv6 including
which systems are to be involved in the hp visualization center sv6
configuration, video timing data, and options to obtain diagnostic
information.
The X0screens file on the hp visualization center sv6 master system
is used to configure the X servers on each of the hp visualization
center sv6 slave systems. This single-file configuration maintains
consistency between all nodes.
NOTE This file must be edited as root and must be located in
/etc/X11/X0screens
• Loading X0screens templates
A template /etc/X11/X0screens file is on the master system.
There are several additional X0screens template files available. Copy
or link the desired (and compatible) template to X0screens. For