HP sv6 - Manual (Page 38)

installation and user information
installation process
Chapter 2 38
hp visualization center sv6 installation
Here are the steps for hp visualization center sv6 system installation
that will be completed by your hp installer:
• Position racks
• Position console monitors
• Connect power & I/O devices
• Configuration
• Boot Up
• Verification
• Run Your Application
Figure 2-10 Anti-Tip Plate
WARNING Pull out or attach the anti-tip plate located at the bottom of each
rack (see Figure 2-10) when systems are being set up and
configured. Failure to do so could cause the entire rack to tip
over. The anti-tip plate should remain deployed. See the hp
visualization center sv6 Site Prep Guide for further precautions.
1. Position rack(s)
Some hp visualization center sv6 solutions require racks of machines
to be located next to each other. Several cabling options between the
racks are necessary to realize full functionality and performance.
Installed Anti-tip
Plate