HP sv6 - Manual (Page 42)

installation and user information
installation process
Chapter 2 42
4. Configuration
For hp visualization center sv6 configurations, follow these
procedures:
5. Boot Up
NOTE BOOT AND CONFIGURE THE MASTER SYSTEM BEFORE
BOOTING THE SLAVE SYSTEMS.
• The boot console on the master will prompt you for a
hostname, an IP address and other system and network
settings.
• After you have answered all of the startup questions, power
on all of the other workstations and network switchboxes.
Table 2-6
Boot up BOOT AND CONFIGURE THE MASTER
SYSTEM BEFORE BOOTING THE SLAVE
SYSTEMS. Have a list of hostnames and IP
addresses to assign to the systems so they will be
visible on your site’s network. Run
set_parms addl_netwrk
to set the master’s network information.
Optional: Set up networking and root passwords
on slave nodes using:
/var/opt/ignite/sps/sv6files/sv_config
See the “How to Use hp visualization center sv6
Tools” section for more information on sv_config.
Specify Compositor serial port If possible, leave the Compositor connected to the
default port on the master workstation (serial port
2, /
dev/tty1p0 ). If you wish to move the
Compositor to a different port, this change must be
specified in the
/etc/X11/X0screens file.
Configure system software When each computer comes up, it can be
customized for the local environment (networking
info, user accounts, passwords, etc.) Ensure that all
systems are compatible with your working
environment before moving to the next step.