Document Outline

• Table of Contents
• Section 1 Functional Description
  • Introduction
    • Intended Use
  • Terminology
    • Mainstream vs. Sidestream
  • Measuring Principle
    • Measurement Calculation
    • Measurement Compensation
  • Hardware Components
    • LC101 Main Board
    • Sidestream Components
• Section 2 LC101 Module Interface
  • Power Requirements
  • LC101 Main Board
  • LC101 Module Interface Connector
  • Watertrap Switch Connection
  • Pump
  • Watertrap Receiver
  • Watertrap Receiver Switch
  • Exhaust Tubing
• Section 3 LC101 Calibration
  • Zero Calibration
    • Zero Calibration Procedure
  • Two-Point User Calibration
    • Two-Point User Calibration Procedure
    • Troubleshooting
• Section 4 Host/Module Communications
  • Communication Interface
    • System EEPROM
  • Packet Structure
  • Host Commands
    • Mode Commands
    • Simple Commands
    • Configuration Commands
    • Calibration Commands
  • Module Responses
    • Status Responses
    • Mode Command Responses
    • Simple Command Responses
    • Configuration Command Responses
    • Calibration Command Responses
  • Software Protocol
    • Packets
    • Faults
    • Module Resets
    • System Behaviors - Dynamic Communications
• Section 5 Pneumatic Operation
  • Normal Flow
  • Pneumatic Events
    • Total Inlet Occlusion
    • Partial Inlet Occlusion
    • Total Exhaust Occlusion
    • Partial Exhaust Occlusion
    • Barometric Out Of Range
    • Unexpected Reverse Flow
    • Unexpected Forward Flow
  • Internal Disconnects
    • Watertrap Receptacle
    • Sensor Inlet/Outlet
    • Flow Control Circuitry
    • Pump Inlet
    • Pump Exhaust
  • Pump Failure
    • Low Flow
    • High Flow
    • No Flow
• Section 6 Regulatory
  • IEC 601-1-2 (EN 60601-1-2)
    • Welch Allyn OEM Technologies
    • OEM
  • Electromagnetic Interference
  • Electromagnetic Susceptibility
  • Compliance Testing Summary
  • ISO 9918 and EN 864
• Appendix A Software Procedures
  • O2/N2O/Desflurane Compensation
    • Correction For O2
    • Correction For N2O & O2
    • Correction For Desflurane
    • Summary of O2, N2O, and Desflurane Compensation
  • Percent CO2 Calculation
  • Zero Calibration Sequence Example
  • Two-Point User Calibration Sequence Example
    • Example of Verification Using Dry Gas
  • CRC
    • CCITT/CRC Code Calculation
  • Software Upgrade
• Appendix B EEPROM Memory Map
  • System EEPROM Map Table
• Appendix C Error Messages & Recovery
  • Advisories
    • LC101 Advisories
    • Pneumatic System Advisories
    • Calibration Advisories
  • Soft Faults
    • Calibration Faults
    • Sensor Faults
    • System Faults
• Appendix D Welch Allyn OEM Technologies Part Numbers and Accessories
  • Module Configurations
  • Accessories Available From Welch Allyn OEM Technologies
• Appendix E Specifications
  • LC101 Main Board
    • Assembly Drawings
  • CO2 Absorber Material Safety Data Sheet (MSDS)
• Appendix F CO2 Developer’s Kit
  • Introduction
    • Disclaimer
  • Software Installation
  • Initial Setup
  • Overview
    • Menu Options Description
    • CO2 Evaluation Platform
• Glossary