Meridian Audio 568 - Manual (Page 61)

54
Setting up the digital surround processor
Audio outputs
The following table gives details of the analogue and digital
outputs:
Use this output To connect to this
MAIN 1-2 Main left and right speakers.
CENTRE/SUB 3-4 Centre speaker and centre or mono
subwoofer.
SIDES/SUB 5-6 Left and right subwoofers, or side left
and side right surround speakers.
REARS 7-8 Left and right rear surround speakers.
To use a Meridian DSP loudspeaker in a particular position
connect it to the appropriate digital output.
To use a Meridian active loudspeaker, or an analogue speaker in
conjunction with a suitable power amplifier, connect the input of
the power amplifier to the appropriate analogue output.
Communications connections
The following table gives details of the communications
connections:
Use this connection To connect to this
COMMS Other Meridian 500 Series
equipment, and the master digital
speaker.
RS232 The serial port of a PC, to
configure the 568. See Configuring
the digital surround processor
using a computer, page 77.
Other connections
The following table gives details of the other connections:
Use this connection To connect to this
BYPASS A digital tape recorder, or second
digital surround processor.
EXPANSION Depends on the expansion card
fitted; consult your Meridian dealer.