Farallon Communications 612 - Manual (Page 61)

Configuration using a PC 4-23
Configuration using DOS
This section describes how to configure the Netopia ISDN Modem
using DOS.
Steps 1 to 3:
Installing the software
1. Create a director y on the hard drive. For example, to create a
director y named netopia on your C drive, at the C:\ prompt
type:
md c:\netopia
2. Inser t the Netopia ISDN Modem Configuration Software for DOS
and Windows diskette into the PC’s floppy drive, and copy all
the files from the diskette to the new DOS director y you just
created. To copy all files from the diskette to the director y,
\netopia, at the A:\ prompt type:
copy a:*.* c:\netopia
3. Change to the director y containing the copied files and type:
install
Steps 4 and 5:
Selecting the COM port
The configuration program launches and presents the Por t
Settings screen. Use the Up Arrow and Down Arrow keys to
move the cursor. Use the space bar to select a parameter.
4. Select the ISDN modem’s COM por t. When you select the por t,
the standard interrupt (IRQ) associated with that por t is
automatically chosen.
Note: The data rate displayed on screen is the speed of
communication between the computer and the Netopia ISDN
Modem.