GE GFK-2489 - Manual (Page 102)

4-8 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489
4
bytes. The Remote can thus buffer up to 1500 bytes of serial data (from the
RTU) before splitting the serial data into separate packets. Each packet, when
transmitted over the air to an AP, is transmitted out of the AP local serial port
as a separate packet. This parameter does not affect serial data/packets
received by the Remote over the air and transmitted out of the local Remote
serial port.
CMD
—Displays all settable optional arguments and their current values. You
can copy this list to a text file as a record of your configuration.
FLOWCTRL=<mode> —Sets or displays the transceiver hardware flow control
status.
Optional arguments:
NONE —Hardware flow control disabled
CTS_CTRL —CTS (Clear-to-Send) flow control
CTS_RTS —CTS follows RTS (Ready-to-Send) flow control
RTS_CTS —DCE RTS/CTS hardware-based flow control
FORMAT=<format> —Sets or displays the COM2 port data characters, parity,
and stop bits setting. Valid data parameters are:
7N1 —seven char bits, no parity, one stop bit
7N2 —seven char bits, no parity, two stop bits
7O1 —seven char bits, odd parity, one stop bit
7O2 — seven char bits, odd parity, two stop bits
7E1 —seven char bits, even parity, one stop bit
7E2 —seven char bits, even parity, two stop bits
8N1 —eight char bits, no parity, one stop bit (default setting)
8N1 —eight char bits, no parity, two stop bits
8O1 —eight char bits, odd parity, one stop bit
8O1 —eight char bits, odd parity, two stop bits
8E1 —eight char bits, even parity, one stop bit
8E2 —eight char bits, even parity, two stop bits
Entering data formats other than those listed above may cause undesired
operation.
INTERGAP —Sets or displays the transceiver inter-packet gap status.
Optional arguments:
IO —For incoming or outgoing serial data
IN —For incoming serial data only
IOL —For incoming or outgoing (low latency) serial data
INL —For incoming (low latency) serial data only