GE GFK-2489 - Manual (Page 112)

4-18 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489
4
STATTRACKER When the STATTRACKER mode is turned on, the Remote transceiver
sends out UDP packets with a broadcast destination IP address. The command has a user-
defined port number between 30000 and 60000, and sends packets consisting of:
• RSSI statistics
• Receive byte errors
• Connectivity
• Transmit byte errors
• Packets received
• Total fragments
• Packets transmitted
• Total retries
• Packets dropped
• Bytes received
• Bytes transmitted
The source MAC address in the UDP packet is the MAC address from the TS Wireless AP.
These monitoring packets are sent out every time there is over-the-air traffic.
This command is designed to work with the MDS Mobility Application available from
Microwave Data Systems (Part No. 06-4157A01).
Optional arguments:
ON: Turns the Stattracker function on
OFF: Turns the Stattracker function off
30000–60000: Allowable range of port numbers that may be entered
CMD—Displays all settable optional arguments and their current values. You can copy this list
to a text file as a record of your configuration.
VER
Displays the current software version information.
Optional arguments:
CMD—Displays all settable optional arguments and their current values.
You can copy this list to a text file as a record of your configuration.
CONFIG= —Displays the Configuration Table version number.
EVENT= —Displays the Event List version number.
H2H= —Displays the Host-to-Host protocol version number.
HREV= —Displays the OIB board hardware version number.
IMAGE=<image>—Displays the number of the currently active image.
LOG= —Displays the current log version number.