GE GFK-2489 - Manual (Page 91)

3-58 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489
3
Hardware Event Triggers Menu
Description Status
A) Frequency Not Calibrated enabled
B) Power Not Calibrated enabled
Please select the event that you want to trigger a Redundancy Switchover on.
Press <SPACE> to cycle through options, <ENTER> to accept, <ESC> to cancel
▪ Redundancy Configuration Options —This selection presents a submenu (see below)
for network event duration settings (for example, if a PING attempt fails after so many
minutes, a contingency action is taken, such as the radio switching from the active to the
standby radio).
Redundancy Configuration Options Menu
The following Events have configurable options
A) Lack of Associated Remotes Exceeded Threshold
B) Packet Receive Errors Exceeded Threshold
Select a letter to configure an item, <ESC> for the prev menu
▪
Force Switchover
—This selection invokes an immediate switcho-ver from the active to the
standby radio.
▪
Network Interface Error
—This selection is used to enable or disable redundancy switchover
on the occurrence of a Network Interface Error. [
Enabled, Disabled; Enabled
]
▪
Frequency Not Calibrated
—This selection is used to enable or disable redundancy
switchover if a frequency calibration error occurs. If this error occurs, the radio requires
factory servicing. [
Enabled, Disabled; Enabled
]
▪
Power Not Calibrated
—This selection is used to enable or disable redundancy switchover if
an RF power calibration error occurs. If an error occurs, the radio requires factory
servicing. [
Enabled, Disabled; Enabled
]
▪
Lack of Associated Remotes Exceeded Threshold
—This selection brings up another menu
where you can specify the duration of time that a redundant AP waits before considering