GE GFK-2489 - Manual (Page 155)

7-4 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489
7
2. Enter + + +
ENTER
3. Change the terminal baud rate to match the transceiver console baud rate.
4. Enter + + +
ENTER
Cannot access the Remote command interface
a. Check for secure cable connections. Serial data cable should be as short as
possible, never exceeding 50 feet (15 meters).
b. Connect to the AP menu and manage the Remote via the Serial Configuration
menu. Check the configuration for COM1 or COM2, as applicable.
Display on terminal or Telnet screen is garbled
a. Verify that the terminal or terminal emulator or Telnet application is set to VT100.
Restart the terminal program.
Cannot pass IP data to the WAN.
a. Verify the AP IP settings.
b. Use the PING command to test communication with the AP and endpoints
connected to Remote radios in the local radio system.
c. If successful with the local PING, attempt to PING an IP radio attached to a radio.
d. If successful with the LAN PINGs, try connecting to a known radio in the WAN.
Wireless retry count is too high
There may be Radio Frequency Interference (RFI).
a. If omnidirectional antennas are used, consider changing to directional antennas.
This often limits interference to and from other stations.
b. Try skipping some zones where persistent interference is suspected, or packets
per zone are disparate.
c. The installation of a filter in the antenna feedline may be necessary.
ConsultTechnical Support for further assistance.
Password forgotten
a. Connect to the transceiver using a terminal through the COM1 port.
b. Contact Technical support. Get a password-resetting Authorization Key.
c. Enter the Authorization Key at the login prompt as a password.