GE GFK-2489 - Manual (Page 105)

GFK-2489 Chapter 4 Remote Radio Management
4-11
4
7: 7 milliseconds
14: 14 milliseconds
28: 28 milliseconds
MODE=<mode>—Sets operation to Direct or Infrastructure mode.
ON: Enter Direct mode
OFF: Enter Infrastructure mode
EXT: Enter Direct mode by external control
NETADDR=<netaddr> —Sets or displays the network (system) address
(0-30000) when in direct mode.
PWR=<range integer>—In ROOT mode, this command sets the radio
power setting in dBm (the range depends on the radio model).
REPEAT=<range integer>—In ROOT mode, this command sets the
Broad-base Repeat Count.
0: Min=0
15: Max=15
RETRY=<range integer>—In ROOT mode, this command sets the
Maximum Unicast Retry Count.
0: Min=0
15: Max=15
SKIPZONES=<bitmap>—In ROOT mode, this command sets the Skip
zones Binary Map (HEX: preceded by 0x).
bit0:ZONE1 ; 1=Skipped 0=Active
bit1:ZONE2 ; 1=Skipped 0=Active
bit2:ZONE3 ; 1=Skipped 0=Active
bit3:ZONE4 ; 1=Skipped 0=Active
bit4:ZONE5 ; 1=Skipped 0=Active
bit5:ZONE6 ; 1=Skipped 0=Active
bit6:ZONE7 ; 1=Skipped 0=Active
bit7:ZONE8 ; 1=Skipped 0=Active
STATE=—(read only) Displays the current Direct mode status.
Currently operating in Infrastructure mode
Currently operating in Direct mode
TYPE= —Sets or displays the role of this radio in Direct mode.
NODE: Operates as one of the Node Remotes