GE GFK-2489 - Manual (Page 121)

GFK-2489 Chapter 5 Sample Configurations 5-7
5
8. The Wizard displays a prompt to select a point-to-point or point-to-multipoint
connection. Press A to select “One Remote” (point-to-point).
Serial Configuration Wizard Menu
With the host connected directly to a serial port, all of its data
will be transmitted over the air. The data can either be transmitted
to a single remote radio, or broadcast to all associated remote
radios at the same time. Would you ike to transmit to one radio
or all associated radios?
Data is currently being sent to All Remotes
A) One Remote
B) All Remotes
Select a letter to configure an item, <ESC> for prev menu, ‘Q’ to quit wizard
9. The Wizard displays a prompt for the Unit ID of the single Remote radio. Press A
to set the Remote ID (generally the last four digits of the Remote serial number).
Type the Unit ID of the Remote radio. Press ENTER to accept the Unit ID. Then
press N to continue.
Serial Configuration Wizard Menu
In order to transmit to a particular remote, you must
specify which remote to which transmissions will go.
A) Remote ID -
B) Continue Wizard
Select a letter to configure an item, <ESC> for prev menu, ‘Q’ to quit wizard