Maxon Telecom MODMAX MM-6280IND - Manual (Page 28)

HSDPA Standard At Commands Page 28 of 61 Version 1.2
2 current
3 forbidden
<AcT> access technology selected
:
0 GSM
1 GSM
Compact
2 UTRAN
1.21. Facility lock +CLCK
Execute command is used to lock, unlock or interrogate a MT or a network facility <fac>.
Password is normally needed to do such actions. When querying the status of a network service
(<mode>=2) the response line for 'not active' case (<status>=0) should be returned only if service
is not active for any <class>.
. This command should be abortable when network facilities are set or interrogated.
Call barring facilities are based on GSM/UMTS supplementary services (refer 3GPP TS
22.088 [6]). The interaction of these with other commands based on other GSM/UMTS
supplementary services is described in the GSM/UMTS standard.
Test command returns facility values supported as a compound value.
Table 17. +CREG parameter command syntax
Command Possible response(s)
+CLCK=<fac>,<mode>[,<
passwd>[,<class>]] +CME ERROR: <err>
when <mode>=2 and command successful:
+CLCK: <status>[,<class1>
[<CR><LF>+CLCK: <status>,<class2>
[...]]
+CLCK=? +CLCK:
(list of supported <fac>s)
+CME ERROR: <err>