Maxon Telecom MODMAX MM-6280IND - Manual (Page 49)

HSDPA Standard At Commands Page 49 of 61 Version 1.2
SDUs. If no error detection is requested, Residual bit error ratio
indicates the bit error ratio in the delivered SDUs. The value is
specified as 'mEe'. As an example a target residual bit error ratio of
5•10
-3 would be specified as '5E3' (e.g. AT+CGEQREQ=…,”5E3”,…).
'0E0' means subscribed value (refer TS 24.008 [8] subclause 10.5.6.5).
<Delivery of erroneous SDUs>: a numeric parameter that
indicates whether SDUs detected as erroneous shall be delivered or
not.
0 - no
1 - yes
2 - no detect
3 - subscribed value
Other values are reserved.
<Transfer delay>: a numeric parameter (0,1,2,…) that indicates the
targeted time between request to transfer an SDU at one SAP to its
delivery at the other SAP, in milliseconds. If the parameter is set to '0'
the subscribed value will be requested (refer TS 24.008 [8] subclause
10.5.6.5).
<Traffic handling priority>:
a numeric parameter (1,2,3,…)
that specifies the relative importance for handling of all SDUs
belonging to the UMTS bearer compared to the SDUs of other bearers.
If the parameter is set to '0' the subscribed value will be requested
(refer TS 24.008 [8] subclause 10.5.6.5).
<PDP_type>:
(see +CGDCONT and +CGDSCONT commands).
If a value is omitted for a particular class then the value is
considered to be unspecified
1.32.7. 3G Quality of Service Profile (Minimum acceptable) +CGEQMIN
This command allows the TE to specify a minimum acceptable profile, which is checked by
the MT against the negotiated profile returned in the Activate/Modify PDP Context Accept
message.
The set command specifies a profile for the context identified by the (local) context
identification parameter, <cid>. The specified profile will be stored in the MT and checked
against the negotiated profile only at activation or MS-initiated modification of the related
context. Since this is the same parameter that is used in the +CGDCONT and +CGDSCONT
commands, the +CGEQMIN command is effectively an extension to these commands. The
QoS profile consists of a number of parameters, each of which may be set to a separate
value.
A special form of the set command, +CGEQMIN= <cid> causes the minimum acceptable
profile for context number <cid> to become undefined. In this case no check is made
against the negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports
several PDP types, the parameter value ranges for each PDP type are returned on a separate
line
.