Maxon Telecom MODMAX MM-6280IND - Manual (Page 58)

HSDPA Standard At Commands Page 58 of 61 Version 1.2
Table 40. + CGPADDR parameter command syntax
Command Possible response(s)
+CGPADDR=[<cid>
[,<cid> [,…]]]
+CGPADDR: <cid>,<PDP_addr>
[<CR><LF>+CGPADDR: <cid>,<PDP_addr>
[...]]
+CGPADDR=? +CGPADDR: (list of defined <cid>s)
Value
<cid>
: a numeric parameter which specifies a particular PDP context definition
(see the +CGDCONT and +CGDSCONT commands). If no <cid> is
specified, the addresses for all defined contexts are returned.
<PDP_address>
: a string that identifies the MT in the address
space applicable to the PDP. The address may be static or dynamic.
For a static address, it will be the one set by the +CGDCONT and
+CGDSCONT commands when the context was defined. For a
dynamic address it will be the one assigned during the last PDP
context activation that used the context definition referred to by
<cid>
. <PDP_address> is omitted if none is available.
1.33. Modem compatibility commands
Table 41. Modem compatibility commands
Command Req Description Support
D Dial(request packet domain service or packet domain IP
service) Supported
1.34. Informative examples
1.34.1. UMTS Connection
Command:
AT+CGDCONT=%CID%,"%PDPTYPE%","%APN%","%PDPADDRESS_NONE%",%DCOMP%,%H
COMP%
Expected response: OK
Command:
AT+CGEQREQ=%CID%,%REQ_TCLSS%,%REQ_MBRUL%,%REQ_MBRDL%,%REQ_GBRUL
%,%REQ_GBRDL%,%REQ_DORDR%,%REQ_MSDU%,"%REQ_SDUER%","%REQ_RBER%",%
REQ_DESDU%,%REQ_TRDELAY%,%REQ_TRHP%
Expected response: OK
Command:
AT+CGEQMIN=%CID%,%MIN_TCLSS%,%MIN_MBRUL%,%MIN_MBRDL%,%MIN_GBRUL%,
%MIN_GBRDL%,%MIN_DORDR%,%MIN_MSDU%,"%MIN_SDUER%","%MIN_RBER%",%MIN_
DESDU%,%MIN_TRDELAY%,%MIN_TRHP%
Expected response: OK