Maxon Telecom MODMAX MM-6280IND - Manual (Page 43)

HSDPA Standard At Commands Page 43 of 61 Version 1.2
+CGTFT?
+CGTFT: <cid>, <packet filter identifier>, <evaluation
precedence index>, <source address and subnet mask>, <protocol
number (ipv4) / next header (ipv6)>, <destination port range>,
<source port range>, <ipsec security parameter index (spi)>,
<type of service (tos) (ipv4) and mask / traffic class (ipv6)
and mask>, <flow label (ipv6)>
[<CR><LF>+CGTFT: <cid>, <packet filter identifier>, <evaluation
precedence index>, <source address and subnet mask>, <protocol
number (ipv4) / next header (ipv6)>, <destination port range>,
<source port range>, <ipsec security parameter index (spi)>,
<type of service (tos) (ipv4) and mask / traffic class (ipv6)
and mask>, <flow label (ipv6)>
[…]]
+CGTFT=?
+CGTFT: <PDP_type>, (list of supported <packet filter
identifier>s), (list of supported <evaluation precedence
index>s), (list of supported <source address and subnet mask>s),
(list of supported <protocol number (ipv4) / next header
(ipv6)>s), (list of supported <destination port range>s), (list
of supported <source port range>s), (list of supported <ipsec
security parameter index (spi)>s), (list of supported <type of
service (tos) (ipv4) and mask / traffic class (ipv6) and
mask>s), (list of supported <flow label (ipv6)>s)
[<CR><LF>+CGTFT: <PDP_type>, (list of supported <packet filter
identifier>s), (list of supported <evaluation precedence
index>s), (list of supported <source address and subnet mask>s),
(list of supported <protocol number (ipv4) / next header
(ipv6)>s), (list of supported <destination port range>s), (list
of supported <source port range>s), (list of supported <ipsec
security parameter index (spi)>s), (list of supported <type of
service (tos) (ipv4) and mask / traffic class (ipv6) and
mask>s), (list of supported <flow label (ipv6)>s)
[…]]
Value
<cid>
: a numeric parameter which specifies a particular PDP context definition (see the
+CGDCONT and +CGDSCONT commands).
The following parameters are defined in 3GPP TS 23.060[47] -
<packet filter identifier>
: Numeric parameter, value range from 1 to 8.
<source address and subnet mask> : Consists of dot-separated numeric (0-255)
parameters on the form 'a1.a2.a3.a4.m1.m2.m3.m4', for IPv4 and
'a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.
m1.m2.m3.m4.m5.m6.m7.m8.m9.m10.m11.m12.m13.m14.m15.m16', for IPv6.
<protocol number (ipv4) / next header (ipv6)>
: Numeric parameter,
value range from 0 to 255.
<destination port range> : Consists of dot-separated numeric (0-65535)