Maxon Telecom MODMAX MM-6280IND - Manual (Page 45)

HSDPA Standard At Commands Page 45 of 61 Version 1.2
+CGQREQ=?
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list
of supported <delay>s), (list of supported <reliability>s) ,
(list of supported <peak>s), (list of supported <mean>s)
[<CR><LF>+CGQREQ:<PDP_type>,(list of supported
<precedence>s), (list of supported <delay>s), (list of
supported <reliability>s) , (list of supported <peak>s), (list
of supported <mean>s)[…]]
Value
<cid>
: a numeric parameter which specifies a particular PDP context definition (see the
+CGDCONT and +CGDSCONT commands).
The following parameters are defined in 3GPP TS 23.107 [46]:
<precedence> : a numeric parameter which specifies the precedence class
<delay>
: a numeric parameter which specifies the delay class
<reliability> : a numeric parameter which specifies the reliability class
<peak>
: a numeric parameter which specifies the peak throughput class
<mean>
: a numeric parameter which specifies the mean throughput class
If a value is omitted for a particular class then the value is considered to be
unspecified.
1.32.5. Quality of Service Profile (Minimum acceptable) +CGQMIN
This command allows the TE to specify a minimum acceptable profile which is checked by the
MT against the negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification
parameter, <cid>. Since this is the same parameter that is used in the +CGDCONT and
+CGDSCONT commands, the +CGQMIN command is effectively an extension to these commands.
The QoS profile consists of a number of parameters, each of which may be set to a separate
value.
A special form of the set command, +CGQMIN= <cid> causes the minimum acceptable profile for
context number <cid> to become undefined. In this case no check is made against the
negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several
PDP types, the parameter value ranges for each PDP type are returned on a separate line.
Table 32. + CGQMIN parameter command syntax
Command Possible response(s)
+CGQMIN=[<cid>
[,<precedence >
[,<delay>
[,<reliability.>
[,<peak>
[,<mean>]]]]]]
OK
ERROR
+CGQMIN?
+CGQMIN: <cid>, <precedence >, <delay>, <reliability>,
<peak>,<mean>[<CR><LF>+CGQMIN: <cid>, <precedence >, <delay>,
<reliability.>,<peak>,<mean>[…]]