Maxon Telecom MODMAX MM-6280IND User Manual
Page 48
HSDPA Standard At Commands Page 48 of 61 Version 1.2
3 - background
4 - subscribed value
If the Traffic class is specified as conversational or streaming, then the
Guaranteed and Maximum bitrate parameters should also be
provided. Other values are reserved.
<Maximum bitrate UL>:
a numeric parameter that indicates the
maximum number of kbits/s delivered to UMTS (up-link traffic) at a
SAP. As an example a bitrate of 32kbit/s would be specified as '32'
(e.g. AT+CGEQREQ=…,32, …). This parameter should be provided
if the Traffic class is specified as conversational or streaming (refer TS
24.008 [8] subclause 10.5.6.5).
<Maximum bitrate DL>:
a numeric parameter that indicates the
maximum number of kbits/s delivered by UMTS (down-link traffic) at
a SAP. As an example a bitrate of 32kbit/s would be specified as '32'
(e.g. AT+CGEQREQ=…,32, …). If the parameter is set to '0' the
subscribed value will be requested. This parameter should be provided
if the Traffic class is specified as conversational or streaming (refer TS
24.008 [8] subclause 10.5.6.5).
<Guaranteed bitrate UL>:
a numeric parameter that indicates the
guaranteed number of kbits/s delivered to UMTS (up-link traffic) at a
SAP (provided that there is data to deliver). As an example a bitrate of
32kbit/s would be specified as '32' (e.g. AT+CGEQREQ=…,32, …). If
the parameter is set to '0' the subscribed value will be requested. This
parameter should be provided if the Traffic class is specified as
conversational or streaming (refer TS 24.008 [8] subclause 10.5.6.5).
<Guaranteed bitrate DL>:
a numeric parameter that indicates the
guaranteed number of kbits/s delivered by UMTS (down-link traffic)
at a SAP (provided that there is data to deliver). As an example a
bitrate of 32kbit/s would be specified as '32' (e.g.
AT+CGEQREQ=…,32, …). If the parameter is set to '0' the
subscribed value will be requested. This parameter should be provided
if the Traffic class is specified as conversational or streaming (refer TS
24.008 [8] subclause 10.5.6.5).
<Delivery order>:
a numeric parameter that indicates whether the
UMTS bearer shall provide in-sequence SDU delivery or not.
0 - no
1 - yes
2 - subscribed value.
Other values are reserved.
<Maximum SDU size>:
a numeric parameter (1,2,3,…) that indicates
the maximum allowed SDU size in octets. If the parameter is set to '0'
the subscribed value will be requested (refer TS 24.008 [8] subclause
10.5.6.5).
<SDU error ratio>:
a string parameter that indicates the target
value for the fraction of SDUs lost or detected as erroneous. SDU error
ratio is defined only for conforming traffic. The value is specified as
'mEe'. As an example a target SDU error ratio of 5•10
-3
would be
specified as '5E3' (e.g. AT+CGEQREQ=…,”5E3”,…). '0E0' means
subscribed value (refer TS 24.008 [8] subclause 10.5.6.5).
<Residual bit error ratio>:
a string parameter that indicates
the target value for the undetected bit error ratio in the delivered