Maxon Telecom MODMAX MM-6280IND - Manual (Page 52)

HSDPA Standard At Commands Page 52 of 61 Version 1.2
Other values are reserved.
<Maximum SDU size>: a numeric parameter (1,2,3,…) that
indicates the maximum allowed SDU size in octets (refer TS
24.008 [8] subclause 10.5.6.5).
<SDU error ratio>: a string parameter that indicates the
target value for the fraction of SDUs lost or detected as
erroneous. SDU error ratio is defined only for conforming
traffic. The value is specified as 'mEe'. As an example a target
SDU error ratio of 5•10
-3 would be specified as '5E3' (e.g.
AT+CGEQMIN=…,”5E3”,…) (refer TS 24.008 [8] subclause
10.5.6.5).
<Residual bit error ratio>:
a string parameter that
indicates the target value for the undetected bit error ratio in the
delivered SDUs. If no error detection is requested, Residual bit
error ratio indicates the bit error ratio in the delivered SDUs.
The value is specified as 'mEe'. As an example a target residual
bit error ratio of 5•10
-3 would be specified as '5E3' (e.g.
AT+CGEQMIN=…,”5E3”,…) (refer TS 24.008 [8] subclause
10.5.6.5).
<Delivery of erroneous SDUs>:
a numeric parameter
that indicates whether SDUs detected as erroneous shall be
delivered or not.
0 - no
1 - yes
2 - no detect
Other values are reserved.
<Transfer delay>:
a numeric parameter (0,1,2,…) that
indicates the targeted time between request to transfer an SDU
at one SAP to its delivery at the other SAP, in milliseconds
(refer TS 24.008 [8] subclause 10.5.6.5).
<Traffic handling priority>:
a numeric parameter
(1,2,3,…) that specifies the relative importance for handling of
all SDUs belonging to the UMTS bearer compared to the SDUs
of other bearers (refer TS 24.008 [8] subclause 10.5.6.5).
<PDP_type>:
(see +CGDCONT and +CGDSCONT
commands).
If a value is omitted for a particular class then the value is
considered to be unspecified.
1.32.8. 3G Quality of Service Profile (Negotiated) +CGEQNEG
This command allows the TE to retrieve the negotiated QoS profiles returned in the Activate
PDP Context Accept message.
The execution command returns the negotiated QoS profile for the specified context
identifiers, <cid>s. The QoS profile consists of a number of parameters, each of which may
have a separate value.