Maxon Telecom MODMAX MM-6280IND - Manual (Page 36)

HSDPA Standard At Commands Page 36 of 61 Version 1.2
Value “READY” MT is not pending for any password
“SIM PIN” MT is waiting SIM PIN to be given
“SIM PUK” MT is waiting SIM PUK to be given
“PH-SIM PIN” MT is waiting phone-to-SIM card password
to be given
“PH-FSIM PIN” MT is waiting phone-to-very first SIM card
password to be given
“PH-FSIM PUK” MT is waiting phone-to-very first SIM card
unblocking password to be given
“SIM PIN2” MT is waiting SIM PIN2 to be given (this
<code> is recommended to be returned only
when the last executed command resulted in
PIN2 authentication failure (i.e. +CME
ERROR: 17); if PIN2 is not entered right
after the failure, it is recommended that MT
does not block its operation)
“SIM PUK2” MT is waiting SIM PUK2 to be given (this
<code> is recommended to be returned only
when the last executed command resulted in
PUK2 authentication failure (i.e. +CME
ERROR: 18); if PUK2 and new PIN2 are not
entered right after the failure, it is
recommended that MT does not
block its operation)
“PH-NET PIN” MT is waiting network personalization
password to be given
“PH-NET PUK” MT is waiting network personalization
unblocking password to be given
PH-NETSUB” PIN MT is waiting network subset
personalization password to be given
“PH-NETSUB” PUK MT is waiting network subset
personalization unblocking password to
be given
“PH-SP PIN” MT is waiting service provider
personalization password to be given
“PH-SP PUK” MT is waiting service provider
personalization unblocking password
to be given
“PH-CORP PIN” MT is waiting corporate personalization
password to be given
“PH-CORP PUK” MT is waiting corporate personalization
unblocking password to be given
1.31. Informative examples
1.31.1. Signal strength reading
Command: AT+CSQ
Expected response: +CSQ: signalstrength,BER
Signalstrength possible values:
0 -113 dBm or less