Maxon Telecom MODMAX MM-6280IND - Manual (Page 46)

HSDPA Standard At Commands Page 46 of 61 Version 1.2
+CGQMIN=?
+CGQMIN: <PDP_type>, (list of supported <precedence>s), (list
of supported <delay>s), (list of supported <reliability>s) ,
(list of supported <peak>s), (list of supported <mean>s)
[<CR><LF>+CGQMIN: <PDP_type>, (list of supported
<precedence>s), (list of supported <delay>s), (list of
supported <reliability>s) , (list of supported <peak>s), (list
of supported <mean>s)[…]]
Value
<cid>
: a numeric parameter which specifies a particular PDP context definition (see the
+CGDCONT and +CGDSCONT commands).
The following parameters are defined in -3GPP TS 23.107 [46]:
<precedence>
: a numeric parameter which specifies the precedence class
<delay> : a numeric parameter which specifies the delay class
<reliability>
: a numeric parameter which specifies the reliability class
<peak> : a numeric parameter which specifies the peak throughput class
<mean>
: a numeric parameter which specifies the mean throughput class
If a value is omitted for a particular class then this class is not checked
1.32.6. 3G Quality of Service Profile (Requested) +CGEQREQ
This command allows the TE to specify a UMTS Quality of Service Profile that is used when the
MT sends an Activate PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification
parameter, <cid>. The specified profile will be stored in the MT and sent to the network only at
activation or MS-initiated modification of the related context. Since this is the same parameter
that is used in the +CGDCONT and +CGDSCONT commands, the +CGEQREQ command is
effectively an extension to these commands. The QoS profile consists of a number of parameters,
each of which may be set to a separate value.
A special form of the set command, +CGEQREQ= <cid> causes the requested profile for context
number <cid> to become undefined.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several
PDP types, the parameter value ranges for each PDP type are returned on a separate line..
Table 33. + CGEQREQ parameter command syntax
Command Possible response(s)
+CGEQREQ=[<cid> [,<Traffic
class> [,<Maximum bitrate
UL> [,<Maximum bitrate DL>
[,<Guaranteed bitrate UL>
[,<Guaranteed bitrate DL>
[,<Delivery order>
[,<Maximum SDU size>
[,<SDU error ratio>
[,<Residual bit error
ratio> [,<Delivery of
erroneous SDUs>
[,<Transfer delay> OK
ERROR