Quality of service profile (requested) +cgqreq – Maxon Telecom MODMAX MM-6280IND User Manual
Page 44
HSDPA Standard At Commands Page 44 of 61 Version 1.2
parameters on the form 'f.t'.
<source port range>
:Consists of dot-separated numeric (0-65535) parameters on the
form 'f.t'.
<ipsec security parameter index (spi)>
: Hexadecimal parameter,
value range from 00000000 to FFFFFFFF.
<type of service (tos) (ipv4) and mask / traffic class (ipv6)
and mask>
:
Dot-separated numeric (0-255) parameters on the form 't.m'.
<flow label (ipv6)>
: Hexadecimal parameter, value range from 00000 to FFFFF.
Valid for IPv6 only.
<evaluation precedence index>
: Numeric parameter, value range from 0 to 255.
Some of the above listed attributes may coexist in a Packet Filter while others mutually exclude
each other, the possible combinations are shown in 3GPP TS 23.060[47].
1.32.4.
Quality of Service Profile (Requested) +CGQREQ
This command allows the TE to specify a Quality of Service Profile that is used when the MT
sends an Activate PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification
parameter, <cid>. Since this is the same parameter that is used in the +CGDCONT and
+CGDSCONT commands, the +CGQREQ command is effectively an extension to these
commands. The QoS profile consists of a number of parameters, each of which may be set to a
separate value.
A special form of the set command, +CGQREQ= <cid> causes the requested profile for context
number <cid> to become undefined.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several
PDP types, the parameter value ranges for each PDP type are returned on a separate line.
Table 31.
+ CGQREQ parameter command syntax
Command
Possible response(s)
+CGQREQ=[<cid>
[,<precedence>
[,<delay>
[,<reliability.>
[,<peak>
[,<mean>]]]]]]
OK
ERROR
+CGQREQ?
+CGQREQ:<cid>,<precedence>,<delay>,<reliability>,
<peak>,<mean>
[<CR><LF>+CGQREQ:<cid>,<precedence>,<delay>,
<reliability.>,<peak>,<mean>[…]]