MACKIE HDR24/96 - Manual (Page 10)

HDR 24/96
You’ll find these System Control buttons in the same relative position on the Remote 48 except
the (-)DEC and (+)INC buttons are found below on the next row of buttons. Since the Remote 48
is designed to control two recorders, a DECK 2 button on this bottom row selects which recorder
you’re controlling.
Menu Navigation
System Control Buttons
Most of the buttons, located immediately above the transport section (“tape deck controls”),
are used to open menus in the LCD interface. These buttons both launch the menu system
and jump directly to designated entry points within the menu.
System and menuing section of the HDR24/96 front panel
Page Left and Page Right Buttons
The large < and > buttons are page navigators. If a menu consists of more than one page,
the top line on the 24 character by 4 line LCD readout will display a
← or → in the upper
left or upper right corner to indicate the direction in which you may page to find more choices
within that menu. The Page Left button can in many instances be used as an Escape key to
exit the current menu level.
Select Buttons
The four SELECT buttons under the LCD are aligned under text describing the choices
available within that menu. Examples include
Exit, OK (confirmation), << >>
(scroll through choices), or Next (move down a menu level). The example above lets you
select which Digital I/O card to configure. Follow the signs, you won't get lost. A SELECT
button is a "soft button" whose function changes depending on the overall operation you’re
performing.
Pairs of SELECT buttons with << >> displayed above them are used to scroll through
choices, or to move a V cursor through a text or numeric field. The V cursor points to the
character you about to change with the (-)DEC and (+)INC (decrement and increment)
buttons.
HDR 24/96 10