Multi-Tech Systems MVPFXS-16 - Manual (Page 16)

Preliminaries & Info Gathering MultiVOIP FXS Quick Start Guide
16
Config Info CheckList
Type of Config Info
Gathered MultiVOIP
Configuration screen
on which to enter Config
Info
√
IP info for voip unit
● IP address
● Gateway
● DNS IP (if used)
IP Parameters
Interface Type
(FXS only*) Interface Parameters
*In FXO/FXS systems, channels used
for phone, fax, or key system are
FXS; channels used for analog PBX
extensions or analog telco lines are
FXO.
Country Code Regional Parameters
Network Locations of SIP Proxy
units, if used
(IP Address or Domain Name)
SIP Call Signaling
Reminder:
Be sure to Save & Apply after entering configuration values.
Identify Remote VOIP Site to Call
When you’re done installing the MultiVOIP, you’ll want to confirm that it is configured and operating
properly. To do so, it’s good to have another voip that you can call for testing purposes. You’ll want to
confirm end-to-end connectivity. You’ll need IP and telephone information about that remote site.
If this is the very first voip in the system, you’ll want to coordinate the installation of this MultiVOIP with
an installation of another unit at a remote site.