Multi-Tech Systems MVPFXS-16 - Manual (Page 46)

Mechanical Installation & Cabling MultiVOIP FXS User Guide
46
19-Inch Rack Enclosure Mounting Procedure
Attaching the MultiVOIP to a rack-rail of an EIA 19-inch rack enclosure will certainly require two persons.
Essentially, the technicians must attach the brackets to the MultiVOIP chassis with the screws provided, as
shown in Figure 3-3, and then secure unit to rack rails by the brackets, as shown in Figure 3-4. Because
equipment racks vary, screws for rack-rail mounting are not provided. Follow the instructions of the rack
manufacturer and use screws that fit.
1. Position the right rack-mounting bracket on the MultiVOIP using the two vertical mounting
screw holes.
2. Secure the bracket to the MultiVOIP using the two screws provided.
3. Position the left rack-mounting bracket on the MultiVOIP using the two vertical mounting screw
holes.
4. Secure the bracket to the MultiVOIP using the two screws provided.
5. Remove feet (4) from the MultiVOIP unit.
6. Mount the MultiVOIP in the rack enclosure per the rack manufacture’s mounting procedure.
x
x
Figure 3-3: Bracket Attachment for Rack Mounting
(MVPFXS-8/16/24)
Figure 3-4: Attaching MultiVOIP to Rack Rail
(MVPFXS-8/16/24)