IBM Aptiva 2142 - Manual (Page 63)

010 (continued)
DOES THE SYSTEM CONFIGURATION REPORT CORRECTLY IDENTIFY
THE DEVICES INSTALLED IN THE SYSTEM UNIT?
Yes No
011
– The System Configuration Report shows only those devices
supported by the Diagnostics and Utilities CD and only
factory-installed devices for the model you are servicing.
– If a device is missing from the list and is not factory installed, refer
to the service manual provided for that device. (Refer to the
Appendix B, “Model/Monitor Configurations and FRU Part Numbers”
on page B-1 to determine the factory-installed devices in the model
you are servicing.)
– If a factory-installed drive device or adapter card is not listed in the
System Configuration Report, return to “Start” on page 2-2 and test
the device. If the device can not be tested, replace the device, then
the system board.
012
– Select Diagnostics Menu from the menu.
– Select Easy Test Diagnostics from the menu.
DOES THE EASY TEST DIAGNOSTICS FINISH WITHOUT ERROR
CODES?
Yes No
013
– If the last test stops and you cannot continue, first make sure all
switches, power connectors, cables, and jumpers are set correctly
and show the correct voltages and continuity.
– Make note of any messages, error codes, beeps, or new symptoms.
Go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-9.
014
– The Easy Test Diagnostics did not detect a failure. If the system still
displays a failure:
Check all adapter card jumper settings.
Check all adapter card switch settings.
(Step 014 continues)
Check Procedures 2-7