IBM Aptiva 2142 - Manual (Page 79)

Table 2-1 (Page 13 of 23). POST and Diagnostics and Utilities Index
for Symptoms, Messages, Error Codes, or Beeps
Symptoms, Messages, Error
Codes, or Beeps Action/FRU
The Address Exceeds The Size
Of Your Memory.
An invalid memory address was
entered. The Diagnostics Tests
display this message during the
Locate Bad Chips option under
the interact menu if an invalid
memory address was entered at
the "Enter Memory Address Of
Bad Chip" prompt. Enter correct address
Memory Module
System Board
That Number is Out Of Range.
An invalid bit number was
entered. Diagnostics Tests
display this message during the
Locate Bad Chips option. Enter the correct number.
Memory Module
System Board
Too Many Errors - Test Aborted.
Too many errors, the Diagnostics
Test cannot continue. Processor
System Board
Transmit Error.
Internal or external serial port
loopback test failure. Serial Port Cable
System Board
Video Adapter Failed.
Test Result Summary, displayed
if "Fail" was at the Quit/Fail/Pass
menu of any video test. Video Adapter
System Board
Display
Write error on cylinder n.
Hard disk drive write error. Hard Disk Drive
Write Errors.
Diskette drive write error. Diskette
Diskette Drive
System Board
Diskette Drive Cable
Write Protected or Unformatted
Diskette is Write Protected or not
formatted. Insert a non-write protected, formatted
diskette into the diskette drive; then rerun
the test.
Diskette Drive
System Board
Diskette Drive Cable
Check Procedures 2-23