0 heating modes, 1 standard mode (factory default), 2 economy mode – Jacuzzi J - 480 User Manual
Page 38: 3 selecting standard or economy mode, 4 clean-up “blow-out” cycle, Heating modes, Standard mode (factory default), Economy mode, Selecting standard or economy mode, Clean-up “blow-out” cycle
Page 34
J-400 Series
10.0 Heating Modes
The control system in your spa activates a programmable “standard” or
“economy” mode which effects when the heater operates. Refer to sections 10.1
and 10.2 below for additional information.
10.1 Standard Mode (Factory Default)
Standard mode is typically selected by customers in cold climates where heat
up times are extended due to lower ambient temperatures. In this mode, water
temperature is regulated by the set temperature which activates the heater auto-
matically as needed.
10.2 Economy Mode
Economy mode is typically selected by customers in warm climates where heat
up times are minimized due to higher ambient temperatures. In this mode, the
water temperature is regulated by the set temperature only when a programmed
filter cycle is running, unless in summer logic (page
).
10.3 Selecting Standard or Economy Mode
Press the MODE
button to select either “Standard” or “Economy” mode.
The control panel’s indicator on the right side of the LCD changes to indicate
which mode is selected.
10.4 Clean-Up “Blow-Out” Cycle
The clean-up cycle is once per day in both Standard and Economy modes at
12:00 (noon) for two minutes. This is not user programmable. Jets pump 2 acti-
vates for one minute to circulate any water in the plumbing. After 1 minute, jets
pump 2 shuts off and jets pump 1 turns on, runs for 1 minute, then shuts off.