2 radio operation, Radio operation, J-400 series – Jacuzzi J - 480 User Manual

Page 57

Advertising
background image

Page 53

J-400 Series

desired setting. A display of “C 0” indicates center, -2 to -12 indicates bass cut,
and +2 to +12 indicates bass boost. Note: Unit returns to volume mode if volume
control is not rotated for 3 seconds.

F. Adjusting Treble Level
Press audio button (20) until display reads “TRE.” Rotate volume knob to
desired setting. A display of “C 0” indicates center, -2 to -12 indicates treble cut,
+2 to +12 indicates treble boost. Note: Unit returns to volume mode if volume
control is not rotated for 3 seconds.

G. Adjusting Balance
Press the audio button (20) until display indicates “BAL.” Rotate volume knob
to desired setting. A display of “C 0” indicates center, L1 to 15 indicates left
balance, R1 to 15 indicates right balance. Note: Unit returns to volume mode if
volume control is not rotated for 3 seconds.

19.2 Radio Operation

A. Adjust Fader
Press audio button (20) until display reads “FAD.” Rotate volume knob to
desired setting. A display of “C 0” indicates center, “R” 1 to 15 indicates rear
fade, “F” 1 to 15 indicates front fade. Note: Unit returns to volume mode if
volume control is not rotated for 3 seconds.

B. Display Clock
Press set button (9) to toggle display between clock and radio modes. When
clock mode is selected, the current time displays whenever the unit is left
undisturbed.

C. Set Clock
Press and hold set button (9) for 2 seconds until first time digit flashes on
display. Use tune/seek-up button (13) or tune/seek-down button (14) to set
hour, noting AM/PM indicator at left. Briefly press set button a second time to
select minutes display. Press set button a third time to complete procedure. Unit
remains in clock mode and displays time after 3 seconds. Note: When power to
spa is shut off for any reason, the clock will be reset to 12:00 AM.

D. Open/Close Front Panel
Place thumb on front panel release button (7) with forefinger below front
overhang. Press firmly on release button, then flip panel open by pulling
outward at top edge. To close panel, flip panel up and press firmly until you
hear an audible click. Keep the front panel closed at all times to prevent water
intrusion, except when changing discs. CAUTION: Never insert wet discs into
unit or CD player will be damaged!

Advertising
This manual is related to the following products: