Jacuzzi J - 480 - Manual (Page 52)

Page 48
J-400 Series
POOR JET ACTION
(see page
26 - 33 )
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page
39 ).
WATER IS TOO HOT 1. Reduce thermostat setting (page 13 ).
2. Switch hot tub to “Economy” mode to turn
heater on only during programmed filter
cycles (page
34 ).
NO HEAT 1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If “heater on” indicator is lit (page
18 ), but no
temperature rise is experienced after a reason-
able period of time, contact your dealer or
authorized service center.
FILTER/CIRCULATION
PUMP OFF 1. Verify filter/circulation pump is programmed
to run 24 hours a day (page 35 ).
2. Filter/circulation pump cycle canceled by
power interruption. Wait 24 hours for hot tub
to reset.
3. Hot tub water is warmer than 95°F (35°C)
and two degrees warmer than the set tempera-
ture. The “Summer Logic” safety feature has
activated. See note on page
36 for details.
Jacuzzi builds the best spas in the industry. Nonetheless, we are always striving
to improve the quality and features of our products. Your input as a Jacuzzi spa
owner is a cherished part of this process. If you have any comments or sugges-
tions, or if you wish to be informed on any new products for your spa, please
write to us.
CONGRATULATIONS on your good taste and welcome to the happiest and
most relaxed family in the world!