Jacuzzi J - 480 - Manual (Page 58)

Page 54
J-400 Series
E. Radio Operation
Press source button (4) to select radio mode. Station frequency is indicated on
display.
• To Select Band: press band button (12) to toggle through radio modes as
follows: FM1 - FM2 - FM3 - AM1 - AM2 - FM1. Each radio band stores up
to 6 independent presets, for a total of 18 FM and 12 AM presets.
• To Program Presets: tune in desired radio station, then press and hold
desired preset button for at least 2 seconds. ”PX”, where X=preset number,
appears at bottom right of the display. Note: When power to spa is shut off
for any reason, all station presets are reset.
F. Automatically Setting Station Presets
To automatically set station presets to their next higher stations, press the
preset button (1 to 6) from which to start programming, then press and hold
the auto button (16) for 3 seconds. The current station preset and additional
preset memories up to P6 will be reprogrammed with their next higher tunable
stations. When the auto preset cycle is complete, the unit will remain in preset
scan mode and continue scanning for presets until the auto button (16) is
pressed. To select only the strongest stations, press the local button (10). All 18
FM and 12 AM presets can be set sequentially by selecting the next band and
continuing the operation during auto programming.
G. Seek/Manual Tune
Press tune/seek-up button (13) once to automatically tune the next higher
station. Press tune/seek-down button (14) once to automatically tune the next
lower station. To manually tune to a specific station frequency, press and hold
either tune/seek button for at least 2 seconds. Holding either button down
will increase or decrease the displayed frequency manually. When the desired
frequency is reached, release the button. The unit remains in manual tune mode
for 3 seconds after either button is released so you can fine tune the station
frequency with additional button presses. Note: After 3 seconds, seek mode is
re-enabled.
H. Scan Functions
Select any AM or FM band and press scan button (11) to listen to a few seconds
of each radio station. The display will flash and the radio will automatically
MUTE
POWER
SOURCE
MRD 60 M A R I N E
INTRO RANDOM REPEAT DISK
LOCAL
SCAN
BAND
SET
TUNE
1 2 3 4 5 6
AUDIO AUTO
TRACK
DISC IN
4
21 19 20 18 17 16 15 14 13
1
12
11
2
3
5 6 7 8 9 10