Spectra Logic 10000 - Manual (Page 16)

Chapter 1. Introduction
16
Fibre Channel Library Rear Panel Components
Fibre Channel Port The Fibre Channel port allows you to choose between three GBICs
for your library cabling.
Ethernet Port This port allows Spectra Logic support technicians to gain information
about your library.
Drive SCSI IDs The drive SCSI ID switches control the SCSI IDs for installed tape drives.
SCSI ID settings for uninstalled tape drives are ignored by the library.
Note: Do not change the default settings for the drives (2, 3, 4, and 5). If
the default settings are changed, the drives will not be recognized.
Library SCSI ID The library SCSI ID switch sets the SCSI ID for the library itself.
Note: Do not change default SCSI ID (6) for the library. If the default
setting is changed, the robotics will not be recognized.
Figure 1-5 The Fibre Channel library’s rear panel components.
Ethernet port
Fibre Drive SCSI IDs
Library
SCSI ID
Power
connector
Serial
port Library
configuration
Fuse
lights
Channel
port